How To Draw An Light Bulb

Steps

1

First of all, y'all will demand a piece of paper. Any size of paper will be fine merely it can't be besides minor. You volition need something hard underneath the paper so you can draw easily. You will also need a pencil, maybe a condom and some colouring pencils if needed.
ii

Describe a circle-like shape similar to the one in the picture. It doesn't accept to be exact. If you lot are really having troubles cartoon it, you tin trace it off your screen.

Advertizing
3

Next, describe two piddling \ and / on each side of the bulb as shown in the paradigm and connect them with a curved line. Don't brand the \ and / too slanted but not too vertical either. Later on that bring together the ends of the lines with a bend every bit shown in the picture. The curved line adds the 3D effect.
four

Depict two zigzags coming down from each side of the line vertically. It should look similar to the 1 in the moving picture.
5

Depict curved lines from 1 of the zigzags to the other. The lines should be parallel to each other and to the line you drew in step three. Bank check out the film below.
6

Draw a vertical line which goes down right the centre of the lesser role of the light bulb and a horizontal line on it. This is to marking the eye for the next footstep. Describe a horizontal line on the vertical one about as far from the lightbulb as is on the picture. This is a marking to assist with the next footstep.
7

Adjacent draw a line from the finish of the zigzag to the place where the 2 lines encounter which you drew in the previous step. These lines should non be directly, rather a little bit curved towards the exterior.
8

Erase the guidelines which you drew in step six and make the bottom of the low-cal bulb slightly curved, not abrupt.
9

If you desire your light bulb turned off you can add some lines and shadows for special effects. Describe them near the edge of the low-cal bulb. The second line (the inner line) should be shorter than the outer one. Yous can too add some shadow furnishings. Shade the within of the light bulb correct next to the border. The closer it is to to the outside, the darker yous should shade it. Only shade a picayune role though, not the whole light bulb, and simply on one side, either left or right.
x

In this pace y'all are going to draw the within of the low-cal bulb. You practise not need to draw this if you don't want to considering the light seedling looks good enough without it. However, if you do want to merely follow this step. Describe a line that is relatively straight, but halfway up it bends to the outside. Draw 2 of these angle in dissimilar directions.
11

Next describe a wiggly/zigzag line connecting one of the lines you lot drew in the previous step to the other ane. This zigzag should non have very abrupt edges. You tin besides draw little loops instead of the wiggly/zigzag line.
12

If you didn't add together shadows to your light seedling yous tin colour it in. If you practice have shadows you tin can try this step to meet how information technology looks simply it might wait very weird. To colour in your low-cal bulb you will demand yellow/orangish and silver/blue. When colouring in the border of the bight bulb, press a bit harder and so it is a little darker while the very inside of the light bulb should be very lightly coloured. The silver/blue colour is for the lesser office of the lite bulb. Don't colour it in too dark so that you tin't see the curved lines you drew in footstep five.
13

Admire the awesome light bulb you drew. It's great!
fourteen

Finished.

Advertisement

Add New Question

Question

Is this piece of cake or hard to do?

This depends on how you lot intend to draw it. If y'all want to describe a bones, calorie-free bulb, drawing information technology only takes a few curves and an oversimplified version of the contents of the seedling. However, if yous desire to depict it realistically, information technology might become challenging.
Question

What is an piece of cake manner to draw a calorie-free bulb?

The method described in this article is quite simple.
Question

How do I draw a cartoon light bulb?

This lightbulb design can be adapted to brand either a realistic depiction or an impression of the bulb. Endeavor drawing a quick sketch of a light bulb and alter it to adjust your style.
Question

How can I go the yellow glow?

Yellow watercolor paints would work. If yous made it darker yellowish in the centre and light on the edges, it would look perfect.
Question

How can I make information technology look similar it is shining?

Describe a band or a jagged line curving around the calorie-free bulb to indicate the lite glowing.